The preparation time and cost, but it is very important, if you can rubber to base material molding products to find the right stripping, ready to work together will get twice the result with half the effort.
Industry, automobile and other industries use injection molding, stamping, transfer or similar functionality rubber to base material molding machine.Forming of elastomer (epdm, natural rubber, nitrile rubber, neoprene) need coated within the cavityRelease agentTo ensure that no residue after removed.
Release agent selection considerations:
- Rapid solidification
- A single coating release agent can adapt to multiple molding cycle
- Mold cavity fouling is less, reduce cleaning time
- Supplier can provide the whole forming process (from the rubber compound and adhesive to release agent) to provide technical services
ourLokRelease™Stripping solution can meet all these requirements.
Using demoulding agent, complete the following three steps can improve demoulding effect:
1. Mould preheating to molding temperature is required.(not coated before release agent of mould should be clean before preheating.)
2. Coating release agent.To improve demoulding effect, can be used with the prolongation of the nozzleHVLPSpray gun, spray the release agent into the groove and the mold cavity.
3. Before the parts molding curing mold release agent.(if the mould not coated before release agent, release agent should be coated with two layer, to enhance the stripping effect, only after coating layer can be.)
Ready to start molding parts!
Many times after molding, need to coating release agent again.Hard to take out parts or elastic parts appearance change, should be coated again release agent.If the mold area is relatively complex, when in trouble, or when the part demoulding touch-up may at any time.If necessary, can be used (plastic) sand removal of mold release agent.
LokReleaseHas the following merits: half a permanent anti-sticking coating, improve liquidity of rubber;Easy demoulding, to prevent the occurrence of defects forming parts;Without coating repeatedly, butTo save time, to ensure production line continuous operation.LokReleaseCan also be solidified into the cavity, and will therefore not be glued to the parts.
